Stamping Industry Solution 4

Stamping Industry Solution 4

Installation of Safety Light Curtain Project at Automotive Forging Department:

Safety light curtains are an important measure to ensure the safety of workers in the automotive forging department. Here is the choosing and installation procedure for your reference:
 
1. Assess the area: Start by understanding the layout and requirements of the automotive forging department. Identify the potential hazards and areas where safety light curtains need to be installed.
 
2. Choose the right type of light curtains: There are various types of safety light curtains available in the market. Consider factors such as height, length, resolution, response time, and the number of beams required to meet your specific safety needs.

 3. Plan the positioning: Strategically position the light curtains to effectively cover the hazardous areas, ensuring they provide adequate protection while minimizing false triggering.

4. Mounting and alignment: Install the light curtains securely, following the manufacturer's instructions. Pay attention to the alignment of the sender and receiver units to ensure accurate detection of any obstructions.
5. Wiring and electrical connections: Connect the light curtains to a control unit or safety relay that will monitor their status. Ensure proper grounding and follow electrical safety guidelines.
 
6. Test and calibration: Thoroughly test the light curtains after installation to verify their functionality. Conduct calibration procedures to adjust sensitivity, range, and other settings, if necessary.
 
7. Training and awareness: Finally, educate the employees about the purpose, function, and proper use of the safety light curtains. Promote a safety culture, encouraging everyone to adhere to the safety protocols.
Featured Products
QE14-40-520-2BB|light curtain sensor|DADISICK
Beam spacing:40mm Number of optical axes:14 Protection height:520mm light curtain sensor output (OSSD):2 PNP
QT14-30-390-2BB|Industrial Light Curtain|DADISICK
Beam spacing:30mm Number of optical axes:14 Protection height: 390mm Area sensor output (OSSD):2 PNP
safety relay
safety relay for Dadisick Safety Light Curtains
QE16-40-600-2BB|security light sensor|DADISICK
Beam spacing:40mm Number of optical axes:16 Protection height:600mm Security light sensor output (OSSD):2 PNP